q. Does the Safetrust SABRE Inline, Module and Relay boards support OSDP ?
Yes. OSDP v1, v2 and v2 with Secure channel are supported.
q. How do I configure OSDP ?
From Admin Installer select the SABRE to be configured, under configuration, change Wiegand to OSDP and select the device number and the communication speed (baud rate), then submit.
The SABRE will be configured for OSDP mode and will begin to respond to the OSDP enabled panels OSDP commands.
When a panel connects to the SABRE, generally the panel sends some beep and LED flash messages to reader to indicate that the reader is online.
q. My reader is not beeping after a card is presented, what has happened ?
In OSDP mode, it is the panel that sends the commands to beep the buzzer and flash the LED. The reader will appear unresponsive to a card read if the panel does not send the audio visual commands to the reader. Check the panel’s software to see if a valid card was read. Also check the communication speed for OSDP on the panel and that the speed is the same for the SABRE.
We’re sorry to hear that. Let us know how we can improve:
Thanks for your feedback! Let us know how this article helped:
Thanks for your feedback!